Removing The Cable And Sfp Module; Configuration - Cambium Networks cnWave Series Quick Start Manual

Removing the cable and SFP module

Do not attempt to remove the module without disconnecting the cable, otherwise the locking mechanism
in the ODU will be damaged.
1. Remove the cable connector by pressing its release tab before pulling it out.
Optical
2. Pull the bale clasp (latch) to the unlocked position. Extract the module by using a screwdriver.
Optical

Configuration

Configuring the management PC
1. Select Properties for the Ethernet port. In Windows 7/Windows 10 this is found in Control Panel >
Network and Internet > Network Connections > Local Area Connection.
2. Select Internet Protocol (TCP/IP).
3. Click Properties.
4. Enter an IP address that is valid for the 169.254.X.X network, avoiding 169.254.0.0 and 169.254.1.1
Connecting 60 GHz cnWave™ Products
Copper
Copper
45