AS MOTOR Ride-on-Allmaher AS 900 ENDURO Operator's Manual page 39

Mounting the steering wheel
2
1
1. Insert the screw (1) through the steering
wheel and the steering column.
2. Tighten the central fixing screw (3).
3. Screw the nut (2) onto the screw (1).
4. Plug on the cap (4).
5. Release the parking break, unlock the
drive and push the mower off the pallet.
6. Relock the drive.
Unloading the device from the pallet
1. Remove the two metal transport securing
devices (one metal hook each is screwed
to the front and the rear).
2. Release the parking break, unlock the drive
and push the mower off the pallet.
3. Relock the drive.
Mounting the mulching kit
If the mulching kit is mounted incorrectly,
4
the device can be damaged.
3
► Make sure that the mulching kit is
1. Switch off the engine, wait for the blade
2. Slacken the knurled nut (1). Remove the
3. Remove the mulching kit (3) from the
Fig. 26:
4. Lift the side cover (5) on the opposite side
5. Remove the contamination in the installa-
6. Place the mulching kit (3) into the support
7. Insert the screw (6)through the opening
8. Lower the side cover (5) again.
Removal of the mulching kit is carried out in
the reverse order of steps.
Caution
between the support bracket and the
cover and the knurled nut is tightened at
all times.
and the engine to stop and remove the igni-
tion key.
knurled nut (1) and the washer (2).
holder.
1
2
6
of the device.
tion area, especially on the support bracket
(4).
bracket (4) located at the bottom of the
cover.
from below and screw the washer (2) and
knurled screw (1) back down.
3
4
5
39