Transfer; Release; Park - Allworx 9224 Phone Manual

8. End the conference by hanging up.

4.4 Transfer

Unannounced (Blind) Transfer
1. Press the TRANSFER button. The current call is placed on hold.
2. At the dial tone, dial the extension to where you want to transfer the call.
3. The call will automatically be transferred. If the recipient does not answer, the call will follow the
recipient's call route.
Announced (Attended) Transfer
To talk to the person to whom you are transferring the call to before the transfer goes through.
1. Press the TRANSFER button.
2. Select a second Call Appearance PFK.
3. Dial the extension to where you want to transfer the call.
4. Talk to the new recipient.
5. Press the TRANSFER button again. The two parties will now be connected.
6. If you want to cancel the transfer, press the RELEASE button. To return to the original caller, press the
Call Appearance PFK where the call is currently being held.

4.5 Release

The RELEASE button is used to hang up an active call or to abort a new call setup, such as the middle of a
transfer operation.

4.6 Park

PBX Behavior on a call appearance
•
To park an active call, press the PARK button.
•
The phone displays for 3 seconds the parking orbit (701 - 709) of where the call is parked.
Key System Behavior on an outside line
•
To place an active call in a "system-wide hold", press the PARK button. Any phone with a PFK for this
outside line will be able to retrieve the call.
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
Phone Guide – 9224
© 2008 Allworx. All rights reserved
Version 1. Revised: October 31, 2008
Page 7