Table of Contents
Advertisement
SMART THERMOSTAT
Specifying the Curve Points
1
The SMART THERMOSTAT only uses this function when it
operates as a stand-alone unit (i.e. when no temperature
controller is detected).
Set the function to SET POINT using the function selector buttons. The
current temperature set point flashes on the display.
Press the second functions push-button. The word OFF is displayed
indicating that the temperature curve is deactivated. If this is not the
case, see below to deactivate the curve.
Repeat the following steps for each of the six points:
Press the second functions push-button once again.
The day number is displayed, alternating with the
word "dAy".
Using the adjustment buttons, set the day number to the desired value.
Press the second functions push-button once again. The current tem-
perature set point flashes on the display.
Using the adjustment buttons, adjust the set point to the desired value.
Once the six points of the curve have been specified, activate the curve as
explained below.
NOTE: Make sure the temperature curve is deactivated before specifying
new points (see below).
18
SMART THERMOSTAT rev.01
Advertisement
Table of Contents
