Table of Contents
Advertisement
Getting Started
3.2.1.3
Additional Hardware Configuration Options
The following tasks are optional, depending on your specific application:
1. Insert any additional CPs needed for your application into the PC station.
2. Insert any HMI devices, for example, text displays or operator panels.
3. Configure the CPU 41x-2 PCI for peer-to-peer communications:
-
Select the controller name in the SIMATIC Manager.
-
Double-click the Connections icon in the right-hand pane.
-
Use NetPro to describe the network.
After you have configured the CPU 41x-2 PCI you can use SIMATIC Manager to
develop and to download your STEP 7 user program.
3.2.2
Connecting STEP 7 to the Controller
You must establish a connection from STEP 7 to the controller to download the
configuration and blocks of the STEP 7 user program. This type of communication
is called PG/OP communication. The controller can connect to STEP 7 in any of
the following ways:
•
Through the virtual backplane bus to STEP 7 on the same computer as the
controller
•
Through the MPI/DP interface to a CP on the computer with STEP 7
•
Through the DP interface to a CP on the computer with STEP 7
•
Through an Industrial Ethernet card configured in the PC Station of the
computer with WinAC Slot to an Industrial Ethernet card on the computer with
STEP 7
Note: Configuring a communications interface in the PC Station requires the
installation of SIMATIC NET, an additional software package.
50
Hardware Installation and Operating Manual, Edition 02/2006, A5E00273194-02
Windows Automation Center, WinAC Slot Version 4.0
Advertisement
Table of Contents
