Table of Contents
Advertisement
Getting Started: Communication between a CPU 416-2 PCI and an S7-400
3. In the Station and Module fields, select the programmable module to be
connected with (connection partner or remote station indicated).
4. Select the connection type (S7 connection only) in the Type field.
5. Select the "Display properties before inserting" check box.
6. Click Apply to confirm. The Properties - S7 Connection dialog is displayed.
7. Check the settings (interface and type) based on the figure above.
8. Click OK to confirm your entries.
This creates the first connection.
STEP 7 enters the connection in the connection table of the local node and assigns
the local ID for this connection. If necessary, STEP 7 also assigns the partner ID
that you need for programming the communication function blocks (value for the ID
block parameter).
These settings conclude the configuration of the START_SLOT project.
9. Use the Save and Compile button to compile.
10. Download the data to the respective station.
98
Hardware Installation and Operating Manual, Edition 02/2006, A5E00273194-02
Windows Automation Center, WinAC Slot Version 4.0
Advertisement
Table of Contents
