Table of Contents
Advertisement
2.2
Fitting the CPU 41x-2 PCI
Procedure
The following table shows you the basic procedure for fitting the CPU 41x-2 PCI.
Step
1
2
3
4
5
6
7
8
Requirement
The CPU 41x-2 PCI requires a PCI slot with standard clearance.
Switching Off and Opening the PC
Caution
The electronic components on the printed circuit boards are extremely
sensitive to electrostatic discharges. Observe the rules for handling
electrostatic sensitive devices (see Guideline for Handling Electrostatic
Sensitive Devices ESD).
1. Switch off the PC and remove the power plug for the 230 V supply on the rear
panel.
2. Open the PC as described in the owners manual for your PC or programming
device.
3. Use switch block S2 on the CPU 41x-2 PCI to specify whether or not battery
monitoring is to be suppressed. You should suppress battery monitoring if you
are not using a battery. Otherwise, the BATF LED would be constantly
illuminated on the controller panel even though no backup battery is being
used.
Note
Switch block 2 is located on the main board of the CPU 41x-2 PCI between
the two circuit boards.
Windows Automation Center, WinAC Slot Version 4.0
Hardware Installation and Operating Manual, Edition 02/2006, A5E00273194-02
Procedure
Switch off the PC
Open the PC
Set up the battery monitoring
Insert the memory card
Insert the CPU 41x-2 PCI into the PC
Connect the CPU 41x-2 PCI to the power supply
Connecting a Fan
Close the PC
Installing the CPU 41x-2 PCI and the Software
27
Advertisement
Table of Contents
