Mechanical Specifications and Installation
2.4.1. Load Capability
Applied loads should be symmetrically distributed whenever possible (i.e., the payload should be centered
on the stage table and the entire stage should be centered on the support structure).
If cantilevered loads are applied, refer to
Figure 2-13
to find the maximum allowable load.
28
Figure 2-9
Figure 2-9:
Figure 2-10:
ADRT100 Cantilevered Load Capability
Chapter 2
ADRT Hardware Manual
to find the loading condition. Refer to
Load Orientations
Figure 2-10
through
www.aerotech.com