Earlier Version Output Connectors; Mating Connector Part Numbers; Rear Panel Pinout Assignments - Agilent Technologies N3280A User Manual

Earlier Version Output Connectors

This appendix documents the earlier version output connectors used on Agilent N3280A units.
Earlier style Agilent N3280A units used a different style output connector with ten (10) pins instead of
the six used on the present connector. The additional pins were used as guard connection points. The
earlier style connector also limited the wire sizes that could be used for output connections. Wires sizes
were limited to AWG 24 and AWG 26. The following table documents the mating part for the earlier
style connectors. These mating parts were not shipped with the unit.

Mating Connector Part Numbers

CHG-2010-J01010-KEP
9821-017-36-AZN
(underline specifies coax length)

Rear Panel Pinout Assignments

The following figure documents the pin-out assignments of the earlier style connectors.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Output 10-terminal output plug for connecting load and sense
connectors wires. Connector installs in the back of the unit. Can be
(for wires) ordered from 3M company (www.3m.com/interconnects)
Output 10-terminal output plug with terminated 36" coaxial
connectors cables. Connector installs in the back of the unit. Can be
(with coax) ordered from 3M company (www.3m.com/interconnects)
E
109