Table of Contents
Advertisement
General Information
Initial Inspection
The Model 7360V Vertical Curing Chamber was tested and inspected before the unit was
shipped from Chandler Engineering. The curing chamber was run through a typical
temperature and pressure profile prior to shipment. Carefully uncrate and inspect the curing
chamber and any accessories. If the unit is received in a damaged condition, immediately
notify Chandler Engineering in writing, and immediately file a claim with the carrier.
Features
The Model 7360V Vertical Curing Chamber is equipped with the following features:
Ramp and soak PID temperature controller.
Variable high pressure limit control. High-pressure limit may be adjusted using high-
pressure limit regulator located on the front panel.
The instrument is equipped with a pump pressure adjustment, which can be used to maintain
the pressure in the instrument above a desired lower limit. If the instrument pressure drops
below the lower limit, the pump will increase the pressure back up above the lower limit.
High temperature alarm
If the cylinder temperature exceeds the limit, the high temperature alarm will cause the heater
to shut off. This is indicated by a lighted pushbutton-switch on the front panel. The high
temperature alarm must be reset manually using the front panel reset switch before the heater
will again become operational.
Specifications
Temperature Control: External 3000-Watt heater and internal thermocouple connected to
Temperature Controller. This controller is capable of ramp and soak or multi-set-point PID
control.
Pressurizing System: The unit is pressurized using an air driven hydraulic pump with water
used as the pressurizing medium. The pressure can be accurately controlled using the HIGH
PRESSURE LIMIT REGULATOR and the PUMP PRESSURE ADJUST REGULATOR.
Maximum Operating Pressure: 6000 psi/41.4 MPa
Maximum Operating Temperature: 600°F/315°C
Heater
PREFACE
P-1
Advertisement
Table of Contents
