Vega VEGABAR 86 Operating Instructions Manual page 49

Code
Text message
F265
Measurement function
disturbed
Tab. 7: Error codes and text messages, information on causes as well as corrective measures
Function check
Code
Text message
C700
Simulation active
Out of specification
Code
Text message
S600
Impermissible electron-
ics temperature
S603
Impermissible operating
voltage
S605
Impermissible pressure
value
Maintenance
Code Cause
Text message
M500 The data could not be restored
during the reset to delivery status
Error in the delivery
status
M501 Index markers are not continu-
ously rising, for example illogical
Error in the non-ac-
value pairs
tive linearisation
table
M502 Hardware error EEPROM
Error in the event
memory
M504 Hardware defect
Error at a device in-
terface
VEGABAR 86 • Foundation Fieldbus
Cause
Sensor no longer carries out a
measurement
Cause
A simulation is active
Cause
Temperature of the electronics in
the non-specified range
Operating voltage below speci-
fied range
Measured process pressure be-
low or above the adjustment
range
9 Diagnosis, asset management and service
Rectification
Carry out a reset
Disconnect operating voltage
briefly
Rectification
Finish simulation
Wait for the automatic end after
60 mins.
Rectification
Check ambient temperature
Insulate electronics
Use instrument with higher tem-
perature range
Check electrical connection
If necessary, increase operat-
ing voltage
Check nominal measuring range
of the instrument
If necessary, use an instrument
with a higher measuring range
Rectification
Repeat reset
Load XML file with sensor data in-
to the sensor
Check linearization table
Delete table/Create new
Exchanging the electronics
Send instrument for repair
Exchanging the electronics
Send instrument for repair
DevSpec
Diagnosis Bits
Bit 11
DevSpec
Diagnosis Bits
Bit 27
DevSpec
Diagnosis Bits
Bit 23
Bit 26
Bit 29
DevSpec
Diagnosis Bits
Bit 15
Bit 16
Bit 17
Bit 19
49