Vega VEGABAR 86 Operating Instructions Manual page 31

Main menu
Application
VEGABAR 86 • Foundation Fieldbus
The main menu is divided into five sections with the following func-
tions:
Setup: Settings, e.g., for measurement loop name, application, units,
position correction, adjustment, signal output
Display: Settings, e.g., for language, measured value display, lighting
Diagnosis: Information, for example, of device status, peak value,
simulation
Additional adjustments: date/time, reset, copy function
Info: Instrument name, hardware and software version, factory cali-
bration date, device ID, sensor features
Note:
For optimum setting of the measuring point, the individual submenu
items in the main menu item "Setup" should be selected one after
the other and provided with the correct parameters. If possible, go
through the items in the given sequence.
The procedure is described below.
The following submenu points are available:
The submenu points are described below.
6.5.1 Setup
In this menu item you activate/deactivate the Secondary sensor for
electronic differential pressure and select the application.
VEGABAR 86 can be used for process pressure and level measure-
ment. Default setting is process pressure measurement. The mode
can be changed in this adjustment menu.
If you have connected no Secondary sensor, you confirm this with
"Deactivate".
Depending on the selected application, different subchapters in the
following adjustment steps are important. There you can find the
individual adjustment steps.
Enter the requested parameters via the appropriate keys, save your
settings with [OK] and jump to the next menu item with the [ESC] and
the [->] key.
6 Set up with the display and adjustment module
31