Table of Contents
Advertisement
User Manual
IKORE B Transmitter
Technical description
IKORE startup
RX
I
II
©
Danfoss | May 2021
1. Insert the EEPROM and fully charged rechargeable BT11K battery.
2. Push and pull out the STOP button.
The status LED will blink in blue until it reaches the stand-by mode and then it will turn into a fixed
blue.
I
II
[1]
3. Press the start button.
The LED will blink green until the transmitter is linked with the receiver.
RX
RX
I
II
I
II
I /I+II /II
* Data sheet
When the receiver confirms the link, the status LED will turn to a fixed green and the system is now fully
operational.
When the system controls two hoists, there will be a push button for the selection of individual or joint
control. I and II LEDs will show their selection.
I
II
[1]
RX
I
II
I /I+II /II
* Data sheet
BC292582855621en-000201 | 7
Advertisement
Table of Contents
