Changing The Power Fuses Or Voltage Setting - Elitech ChloroChek Chloridometer 3400 User Manual

WARNING!
Risk of electrical shock: Unplug the unit from the power supply before attempting to replace the fuses.
Use the following instructions to replace fuses or to change the voltage setting to the local output. Use the
correct rating of fuses for the power setting to be used.
1 To replace the fuses, use a small screwdriver to remove the fuse holder on the rear of the unit.
2 Remove and replace the two fuses. The unit has two-phase protection. Use the following fuses:
NOTE:
When inserting the fuse holder, return it to its original position (with the correct voltage setting directly below
the power input socket). The arrow should point up to the correct line voltage indicated on the fuse holder.

4.5 Changing the Power Fuses or Voltage Setting

200-240 VAC power supply: 0.5 A slow/LAG
100-120 VAC power supply: 1 A slow/LAG
MAINTENANCE AND TROUBLESHOOTING
SECTION 4
31