Polaris PROSPECTOR PRO User Manual page 35

Lubrication
C. Wheel Shaft and Seal Bearing -
Apply 1-1.5 cc of grease on the
wheel shaft and seal bearing. Apply
grease evenly over the entire width
and circumference.
D. Hub - After replacing hub housing
bearings and reinstalling hub, slowly
pour 2 teaspoons (8-10 cc) of 80W90
grade oil through the hole on the top of
the hub housing. Do not overfill, pour the
recommended amount of oil.
E. Hub Bearing Seals - Apply 1.5-2 cc of
grease evenly between the hub seal's
lips and over the entire circumference of
the seal.
IMPORTANT : Make sure the hub seal is installed
flush with the hub face. It should
not extend beyond the hub face.
F. Hub Speed Sleeve - Apply 1-1.5 cc of
grease over the entire width and
circumference of the sleeve.
G. Frame Tubing, Tensioner Side -
the tensioner to its furthest point out.
Apply evenly a thin coat of grease,
oil or spray lubricant on the outside
of the tensioner tubing, over the
entire circumference. Always realign
the tensioner when it has been
disassembled.
NOTICE : Application of lubricant on the tensioner tubing prevents corrosion
inside the frame's tube. Lubrication allows the tensioner to move
freely when adjusting track
MAINTENANCE
C
Slide
tension.
D
E
F
35