About - Dynamic Rhino Conversion Manual

About

This manual can help you convert an existing Rhino-based scooter system to a RHINO2 scooter system.
This manual must be read together with all other relevant scooter component manuals.
In this manual, a few symbols will help you identify the purpose of the paragraph that follows:
Notes:
Notes provide supporting information in order to install, configure, and use the product. Not following the
instructions given in notes or precautions can lead to equipment failure.
Warnings:
Warnings provide important information that must be followed in order to install, configure, and use
the product safely and efficiently. Not following the instructions given in a warning can potentially
lead to equipment failure, damage to surrounding property, injury or death.
The term 'programming' used in this manual refers to adjusting parameters and configuring options to suit an application.
'Programming' does not change or alter any software within the controller and is performed using a controlled
programming tool available only to authorised personnel.
The product is not user serviceable. Specialised tools are necessary for the repair of any component.
Do not install, maintain or operate this equipment without reading, understanding and following this manual – including
the Safety and Misuse Warnings – otherwise injury or damage may result. This manual contains integration, set-up,
operating environment, test and maintenance information needed in order to ensure reliable and safe use of the product.
Due to continuous product improvement, DYNAMIC CONTROLS reserves the right to update this manual.
This manual supersedes all previous issues, which must no longer be used.
DYNAMIC CONTROLS reserves the right to change the product without notification.
Any attempt to gain access to or in any way abuse the electronic components and associated assemblies that make up the
scooter system renders the manufacturer's warranty void and the manufacturer free from liability.
DYNAMIC CONTROLS, the DYNAMIC CONTROLS logo, the RHINO logo, the RHINO2 logo are trademarks of Dynamic
Controls. All other brand and product names, fonts, and company names and logos are trademarks or registered
trademarks of their respective companies.
DYNAMIC CONTROLS owns and will retain all trademark rights and DYNAMIC CONTROLS or its licensors own and will retain
all copyright, trade secret and other proprietary rights, in and to the documentation.
All materials contained within this manual, in hardcopy or electronic format, are protected by copyright laws and other
intellectual property laws.
© Copyright 2011 Dynamic Controls. All rights reserved.
Rhino to RHINO2 Conversion Guide Page 2