Pro-Cmb-S - Tamper-Switch (Pro-Cmb-S) - Xtrails ADPRO PRO-18 Planning And Commissioning Manual

Planning and Commissioning Manual

Pre-wired for easy and fast installation

Off-site assembly preparation (address, parameter pre-setting etc.) to keep expensive
parts in a safe environment until they were needed)

Plug & Play final installation
An integrated 14-pin terminal in the base plate allows seperate wiring and detector
installation for an efficient work.
The bracket is retractable and can be opened at any time for maintenance or service
reasons. For your safety and convenience (hands-free) the bracket is kept in a retaining
fixture.
An additional pole mount accessory is also available as an option for hidden cabling on poles
to protect against vandalism.
12.6.1 PRO-CMB-S — Tamper-Switch (PRO-CMB-S)
In some applications or in some standards a removal from mounting surface is required. As
these requirements may not be covered by the "Tilt Alarm" an additional tamper-switch can
be built-in into the cable managed bracket. This tamper-switch is optional available as a
retro-fit kit.
The design and position of this tamper-switch is done in that way, that the removal from the
mounting surface, as well as the opening of the base-plate with the cable terminal inside, is
detected. This switch can be used as a separate zone or can be connected to the tamper-
switch/tilt alarm of the detector housing. Refer to quick setup guide, provided with the
product shipment of PRO-CMB-W.
74
ADPRO Passive-Infrared (PIR) PRO Series by Xtralis
Doc. 20780_03