Tool - Xtrails ADPRO PRO-18 Planning And Commissioning Manual

Planning and Commissioning Manual
4. Detector's status, it is represented with an arrow which color changes according to
the current status as follows:
You can control the Scope view through the following:
Run the Scope
Stop the Scope
Select Scope view mode
Increase signal speed
Decrease signal speed
Clear Scope view
Delete all triggers
As shown in the table above, there are two scope modes:

Scroll Mode: If checked, the signal is continuous and its direction is from right to left. If
unchecked, the signal's direction is from left to right and each time <F6> key is pressed
the signal starts from the beginning.
To switch between Scroll modes press <F6>.

Grid: If selected, horizontal and vertical lines appear on the Scope in addition to the
signals.

10.3.6 Tool

This menu enables you to take pictures of the scope and save them in the computer, view
statistics of alarm states, and identify communication problems, etc.
Tool menu appears as follows:
The following sections discuss all the actions you can perform.
64
ADPRO Passive-Infrared (PIR) PRO Series by Xtralis
: OK
: Fault
: Synchronizing
NOTE!
Display of DIP-switches may vary depending on detector model.
DIP-switches values are controlled from the detector itself. A table that
shows the switches functions is available on a sticker on the detector's
lid.
Action Button
Run
Stop
Scroll Mode
Grid
Step up++
Step down- -
Clear
Trigger Delete ALL
Shortcut
<F5>
<Ctrl> + <F5>
<F6>
<F7>
<F8>
<Ctrl> + <F8>
<F9>
<F10>
Doc. 20780_03