Recessed Installation - CAME AGT A200K Installation Manual

Recessed installation

The HTS recessed box must be walled in
fl ush at a suitable height, using the spacer
provided to prevent box deformation
In systems where the Larsen eff ect might
occur, the microphone can be mounted re-
motely
To remove the microphone from its hous-
ing, pry it off from its base using a small
screwdriver, taking care not to damage
the cabling
Before inserting the microphone into the
bottom of the back-box, use pliers to remove the part that is
highlighted .
Insert the audio unit near the top of the back-box
Fit the microcontact (bottom right) into the correct housing
The front plate is equipped with a common call for the
microcontacts, to be used when other buttons are to be
installed (maximum of 4)
Insert the lighting unit in the relevant housing
Remove the two protective seals on the holes in the recessed
box and attach the back-box using the two screws provided
Make the connections and secure the cables using the cable
holder .
The cable holder must be located near to the audio unit.
.
.
.
.
.
.
.
.