Viavi ONA-800 Getting Started Manual page 31

Hide thumbs Also See for ONA-800:
Table of Contents

Advertisement

Chapter 2 Setting up the system
Setting up the Job Manager
1
Ensure that the unit will have an uninterrupted supply of power during the update.
If necessary, connect the AC power adapter to the unit.
2
Select System on the menu bar, select Upgrade, and then select Network.
3
Do one of the following:
a
b
4
Select Connect.
5
After the unit accesses the server, select the link for the software file for the unit.
Note the following symbols that may appear beside the release number of the
software file:
6
Select Start Upgrade.
A dialog box appears with prompts to either exit all tests that are running or cancel
the update if the tests cannot be stopped.
7
Select OK to begin the software update.
The unit automatically restarts when the update is completed.
NOTE
The software update can take several minutes, depending on the speed and reliability
of the network.
Setting up the Job Manager
Test Process Automation (TPA) supported via the Job Manager Icon includes Techni-
cian Guidance. A step-by-step walk through of the testing tasks associated with the job
includes being able to launch the job or to review a job guide for the specific task. After
all tasks are completed the technician will be notified and prompted to return to the Job
Manager.
Page 20
WARNING:
Electrical shock may result in serious injury or death. Be sure the AC power
adapter is connected to the correct voltage mains. Do not use the adapter
outdoors or in wet locations. Use only the AC power adapter supplied with
the unit.
Enter the server address where the update is located.
Enter the address where the software file is located; for example, the FTP
address, server IP address or host name, and the proxy server address (if
necessary), as well as the access credentials.
An equals symbol indicates that the software on the USB stick and the
software on installed on the unit are the same (that is, have the same release
number).
A down-arrow symbol indicates that the software on the USB stick is an
earlier release than the software installed on the unit.
An up-arrow symbol indicates that the software on the USB stick is a later
release than the software installed on the unit and the system software can
be upgraded to the later release.
ONA-800 Getting Started Guide
22142812, D1 R004
August 2020

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ona-800a-mf

Table of Contents