Attaching Modules; Caa/Otdr Modules; Solution Modules - Viavi ONA-800 Getting Started Manual

Chapter 1 Getting started

Attaching modules

Attaching modules
This section describes how to attach CAA/OTDR modules and solution modules to the
ONA-800.

CAA/OTDR Modules

The following procedure describes how to attach CAA/OTDR modules to the ONA-800.
To attach CAA/OTDR modules
1 Power down the ONA-800 and disconnect from AC power.
2
Place the unit so that you have access to the back and remove the termination
cover by removing the screws that hold it in place.
3 Locate the hinges on the module and insert them into the base at a 45 to 60
degree angle.
4
Pivot the module down towards the connector.
5 Seat the module into the connector with slight pressure.
6
Tighten the screws on the module.
The following procedure describes how to remove CAA/OTDR modules.
To remove CAA/OTDR modules
1 Power down the ONA-800 and disconnect from AC power.
2 Place the unit so that you have access to the back.
3 Remove the screws on the module.
4 Remove the module from the ONA-800.

Solution modules

The following procedure describes how to install a solution module to the ONA-800.
To attach a solution module
1 Power down the ONA-800 and disconnect from AC power.
2 Place the unit so that you have access to the back and remove the termination
cover by removing the screws that hold it in place.
3 Set the module onto the base, ensuring the mating connectors between the two
pieces are aligned, as shown in
Page 6
Figure 7.
ONA-800 Getting Started Guide
22142812, D1 R004 August 2020