Table of Contents
Advertisement
Transport Lock Pin
A locking pin is used to fix the machine in transport position. In transport position the pin will go through the
mainframe and hold the drum frame in place. The pin is then secured with a snap pin.
To put the machine in working position, remove the pin and lower the drum frame. This will clear the locking
hole for the locking position. The lock up pin can then be stored and secured with the snap pin as shown.
Transport Position
Driveline Shield Chains
Attach PTO shield chain to tractor or windrower hitch allowing sufficient slack for turning.
OSHA, ASABE, and SAE standards require that all rotating shafts be guarded against
contact. The unchained plastic shields can rotate with the driveline but must stop when they
contact another object. (Note: These shields may also be chained.)
The shields must be regularly greased and checked that they rotate freely on the driveline. Refer to the
Lubrication section for greasing intervals.
SRW1000 08/17
© 2017 Alamo Group Inc.
ASSEMBLY
Assembly Section 3-10
Working Position
Advertisement
Table of Contents
