Before Operation - Schulte SRW1000 Operator's Manual

ASSEMBLY

Before Operation

THE GEARBOX IS SHIPPED DRY. FILL WITH GEAR OIL BEFORE OPERATING.
Refer to the Maintenance Section of this manual for recommended oil type and viscosity.
Lubricate all grease fittings. Refer to the grease schedule in this manual.
Remove the chain case cover and check that the drive chain is properly tensioned and lubricated.
Refer to the Maintenance Section of this manual.
Check that all nuts and bolts are in place and properly tightened. Refer to the Maintenance Section of this
manual for proper bolt grades and torques.
Check that the wheel standard axle plates are set properly. The center of the lower 5/8" mounting bolts must be
set to a maximum 2-1/4" from the bottom of the pivoting wheel standard legs as shown below. A setting higher
than 2-1/4" may result in the tires contacting the drum.
Check tire inflation pressure. Higher pressures may cause excessive bouncing over rough ground. Lower
pressure may cause excessive wear. Refer to maintenance section for recommended tire pressure.
Gearbox output driveline should be installed with the shear bolt torque limiter at the gearbox.
SRW1000 08/17 Assembly Section 3-8
© 2017 Alamo Group Inc.