Off Position; Program Selector; Display; Temperature Setting Button - ECG EWF 1280 IDA+++ Instruction Manual

OFF position

Set to OFF position to turn the washing machine off .

Program selector

Use the program selector to choose the appropriate program according to the degree of soiling and for the
type of laundry, see "Program table".

Display

• When the washing machine is switched on, the display shows the spin speed and additional information
about the selected program.
• During washing, the remaining time is displayed on the display until the washing is over.
GB
• In the event of a malfunction, the display shows the error code.

Temperature setting button

Use the temperature setting button to set the desired washing temperature.

Spin speed button

Use the spin speed button to set the maximum spin speed, see the programs table above.

Delayed end button

Use this button to delay the start of the program.
• Use the Start/Delay end button to set the desired end of washing interval.
• Use the Start/Pause button to start the countdown.
Note: The set time must be always longer than the length of the set program.
WARNING: The display data shows in how long the program will be completed.
To cancel the delayed start function, press the power button. Then the delayed start can be set again.
To start the delayed start countdown, the machine must be started by pressing the Start/Pause
You can not use the delayed start function when selecting the "Spinning" program.

EXTRA rinse button

Use this button to add an extra rinse to the program.
Note: The number of additional rinses is limited in some programs.

Program completion

When the selected program is completed the washing machine stops automatically.
• The program completion light fl ashes on the panel.
• You can open the washing machine door and remove the laundry.
• Leave the door of the washing machine open to dry the interior of the washing machine after you remove
the laundry.
• Turn the program switch to OFF.
• Unplug the washing machine.
• Close the water supply.

Using additional functions

Before starting the program, you can select an additional function as needed.
• Press the additional function button.
• If the additional function symbol lights up on the display, the selected function will be activated.
• If the additional function symbol fl ashes, the selected function cannot be activated.
82
EWF 1280 IDA+++_manual_cz_sk_de_en.indb 82
button.
06.05.2019 17:41:38