Disassembly And Assembly; Disassembly - EBARA GS Instruction Manual

10 Disassembly and Assembly

※
Disassembly/assembly and repair of the pump should only be performed by specialist maintenance
technicians. Otherwise, error by personnel can result in serious physical injury and/or equipment
damage.
※
Always disconnect and lock out power to the driver before you perform any installation or
maintenance tasks. Failure to disconnect and lock out driver power will result in serious physical
injury.
※
The unit and the components can be heavy. Use proper lifting method.
※
Allow all system and pump components to cool before you handle them to prevent physical injury.
※
The pump can handle hazardous and toxic fluids. Identify the contents of the pump and observe
proper decontamination procedures to eliminate the possible exposure to any hazardous or toxic
fluids. Wear the proper personal protective equipment. You must handle and dispose of pumped
fluid in compliance with the applicable environmental regulations.
※
Avoid injury. Some components can have sharp edges. Wear appropriate gloves while handling
these parts.
※
Make sure that all replacement parts are available before you start to assemble/disassemble the
pump.
※
Make sure that all appropriate tools are available before you start to disassemble/assemble the
pump.

1. Disassembly

Model GS
STEP.1
Drain all water from Casing (35).
STEP.2
Remove the Protectors (14) from the Bearing
Casing (11).
STEP.3
Remove the Stay (12) from the Bearing Casing
(11).
- 25 -