Operating Modes - EdilKamin Idrotech Installation, Use And Maintenance Manual

THE INTERFACE
Panel with display and 4 keys
0/1 : to turn on and off.
Menu: to access the menu
+ and -to increase/decrease the various settings.
USE
Before ignition. 1st Ignition: contact your local DEALER.
The first few times the stove is ignited there may be a slight smell of paint, which disappears rapidly.
Before ignition, check:
• that the stove has been installed and water connected correctly (make sure the system has been bled).
• The power supply.
• THE SWITCH ON THE ELECTRIC SOCKET BEHIND THE STOVE IS TURNED TO 1.
• the door is closed.
• the combustion chamber is clean.
• the display is on standby.
SCREW FEEDER LOADING.
If the pellet hopper empties, press the + and - keys together to fill the screw feeder.
This must be done before igniting the stove again if it has shut down due to running out of pellets.
It is normal for a few pellets to be left in the hopper, which the screw feeder is not able to pick up.
IGNITION
Automatic ignition
Hold the 0/1 key down for two seconds with the stove on standby to start the ignition procedure. The word Start appears on the
display for a few minutes (ignition does not take a preset time:
it is automatically shortened if the electronics detect that certain tests are passed). The flame appears after about five minutes.
It is normal for a little smoke to be seen in the combustion chamber before the flame appears. Start remains on the display until the
flame is stable.
Manual ignition
At temperatures of less than 3°C (too low for the heating element to glow) or if the heating element is temporarily out of order, a
firelighter may be used for ignition. Put a piece of well lit firelighter into the combustion chamber, close the door and press the 0/1
button.

OPERATING MODES

Set the water temperature required in the system (60°C recommended) on the panel. The stove modulates the power to maintain or
reach this temperature.
The Eco function may be enabled for small systems (see DEALER adjustments). In this case, the stove turns off when the water
reaches the set temperature and turns back on again to modulate the power.
Pressure gauge
It is mainly useful to technicians.
It is located on the rear left of the stove and shows the
water pressure in the system. The pressure must always be
between 1 and 1.5 bars when the stove is running.
- 30
-