EdilKamin Idrotech Installation, Use And Maintenance Manual page 28

Boiler-stove system as unique heat source, with water heater for
domestic hot water production
This layout is purely indicative. Have a plumber design and install the system.
CAUTION: domestic hot water production reduces the heating power of radiators.
ACCESSORIES
The diagrams above only include components available on the EdilKamin price list.
• Kit 4 (cod. 264290) pre-assembled kit for boiler-stoves for producing domestic hot water (20 plate heat exchanger,
power-driven three-way valve, high temperature drain valve, flow switch and electronic regulator.).
• Optional extra for wall installation (cod. n. 262140)
• Water heater with one (cod. 264750) or two (cod. 264760) fixed heat exchangers for producing and storing domestic hot
water. 150 l capacity.
Spare parts are also available (heat exchanger, valves, etc.).
1st IGNITION (DEALER)
Make sure that the plumbing has been correctly installed and fitted with a sufficiently sized expansion tank to assure safety.
The expansion tank built into the boiler-stove does not provide suitable protection against the thermal expansion of the water in
the whole system.
Turn the stove power supply on and carry out cold tests (DEALER).
Fill the system through the filling valve (do not exceed 1 bar in pressure).
While filling, "bleed" the pump and the bleed valve.
- 28
-
LEGENDA
ACS: Domestic Hot Water
AL:
Water supply
B: Water heater
C: Filling/Topping up
EV2:
Two-way solenoid valve
EV3: Three-way solenoid valve
NA: Normally Open
NC: Normally Closed
GR: Filling unit
M: Mixer valve
MI:
Outlet to system
P: Pump (circulator)
RA: Radiators
RE:
Electronic regulator
RI: Inlet from system
S: Drain
SI:
Immersion probe
TS: Boiler-Stove
V: Ball valve
VA:
Automatic bleed valve
Vec: Closed Expansion Tank
VSP: Safety pressure valve Internal
stove components Manifold