EdilKamin Idrotech Installation, Use And Maintenance Manual page 29

Mounting the stove covering made of ceramic tiles
Parts of the stove covering
The list of parts that form the stove covering
• 8 lateral tiles (30)
• top ceramic insert (29)
• ceramic insert (41)
• rear plate that blocks the tiles (35)
• 2 aluminium profiles (34)
NOTE
The numbers reflect those in the figures where the codes are
found.
Stove covering assembly
WITHOUT REMOVING THE TOP, after having installed the
stove correctly, proceed as follows.
Lateral ceramic tiles.
Proceed as follows to mount the ceramic tiles on to the sides of
the stove:
- Loosen the fastening bolts (left and right) of the rear plates
that block the tiles (part n° 35).
- Place the 10x2 gasket (code 425810) 870 mm long onto the
lateral plate on the back part of the galvanised side; left and
right (fig. 1).
- Place the ceramic tiles.
- Put the rear plates that block the tiles back in place and
tighten the bolts.
Ceramic top
This component (29) is placed in the appropriate grooves.
Ceramic insert (41)
USE SILICONE to set the component in place (43).
Mounting the stove covering made of steel
(detail n 123 code list pg. 113)
The stove is delivered with the sides already assembled; to
dismantle them, loosen the 8 bolts that fasten the two lateral
panels and remove them from the aluminium plates (part n°
34).
fig. 1
Attention:
When the stove is ignited for the first time, open the valve (V)
found below the top plate, so as to bleed off the air/water.
Insert the tube (T) supplied into the spout of the bleed valve
and open the valve with a screwdriver until all the air is let
out.
- 29
-