Technical Data; Safety Advice; Assembly - Miomare 273497 Operation And Safety Notes

Technical data

Connections: G ⅜
Shower hose: G ½ , length 120 cm

Safety advice

INJURY AND ACCIDENTS FOR
INFANTS AND SMALL CHIL-
DREN! Never leave children unsupervised with
the packaging materials. Danger of suffocation.
Keep out of the reach of children. It is not a toy.
BEWARE OF ELECTRIC SHOCK!
Any leaks or the escape of water can
lead to danger to life from electric
shock. Carefully check that all connections are
watertight. Also ensure that all wires of electric
appliances are correct and have been securely
installed.
CAUTION! RISK OF INJURY! Please ensure
that no parts are damaged and that all parts
are correctly assembled. Incorrect assembly
could lead to injury. Please note that washers
and gaskets are wear parts and therefore will
need to be replaced from time to time. Dam-
aged parts could adversely affect safety and
proper function.
CAUTION! Ensure that the hot / cold water
plaque has been attached the right way
17
round. The correct position is: left = red (hot
water), right = blue (cold water).
ATTENTION! DANGER OF MATERIAL
DAMAGE! Installation may only be carried
out by experts. Leakage or escape of water can
cause significant damage to buildings and house-
hold contents. All connections must therefore be
checked carefully to ensure that they are tight.
Ensure that all seals are correctly seated to
avoid escape of water due to leakage.
Familiarise yourself with all local conditions, e.g.
water connections and shut-off device, prior to
installation.
We recommend the installation of a filter or an
angle valve. In this way you will protect the
entrance of the taps from foreign bodies and
protect the cartridge
RISK OF FATAL
from damage.
20
Introduction / Safety advice / Assembly
The product is intended to be only used in
rooms with a temperature above 0 °C. In case
of potential frost, cut off the water supply and
drain the taps.

Assembly

Note: Familiarise yourself with the product prior to
assembly. Carefully read the following assembly
instructions and safety advice. In the event of incor-
rect installation, all warranty claims – particularly
in relation to subsequent damage – are excluded.
CAUTION! Before you start installation turn
off the water supply at the mains. Otherwise
there is a danger of injury and / or damage to
the product.
CAUTION! Do not twist the connection hoses
, or place them under tension.
10 12
Note: To do this you will require a Phillips
screwdriver, a slotted screwdriver and an
open-end wrench SW 9 mm.
Follow these steps:
CAUTION! Ensure that you only tighten the
connection hoses
10
pliers or a wrench. Otherwise the product
could be damaged.
Screw the two long connection hoses
hand into the two external bores in the tap.
Screw the short connection hose
into the middle bore of the tap.
Insert the free end of the shower hose
the top through the tap body
Using a slotted screwdriver, screw the two thread
bolts as far as they will go into the tap
15
body and remove the two securing nuts
2
Lay the sealing ring
of the tap body
2
ing on your sink.
Under the sink, first place the plastic triangle
, the C sealing washer
7
washer over the threaded bolts
9
The screw the two locking nuts
thread bolts and tighten then with the open-
15
end spanner SW 9 mm until the tap is seated
firmly on the sink.
, manually. Do not use
12
by
10
by hand
12
from
5
.
2
in the nut on the bottom
6
and plug this into the open-
and then C metal
8
.
15
onto the
14
GB
.
14
7