Introduction; Intended Use; Parts Description; Technical Data - Miomare LED Bath and Shower Mixer Tap Assembly, Operating And Safety Instructions

Introduction

LED Bath and Shower Mixer Tap
Introduction
Congratulations on the purchase of your
new product. You have selected a high
quality product. The assembly and oper-
ating instructions are part of this product. Please
carefully read these assembly instructions / instruc-
tions for use before use and observe all instructions.
These assembly instructions and instructions for use
contains important assembly, set-up and care infor-
mation. Please retain these assembly instructions /
instructions for use and hand them on to any future
owner.

Intended use

The product is only designed to regulate the hot and
cold water flow. For tub installation only. Suitable
for use with all pressure-resistant hot water systems
such as central heating, continuous-flow water heater,
pressure boiler etc. This product is not suitable for
low pressure water heaters or pressure-free small
storage reservoirs, e.g. wood- or coal-burning do-
mestic hot water heaters, oil or gas-fired hot water
heaters, or open electrically heated cylinders. When
in doubt please consult a plumber or heating spe-
cialist. Any use not specified or product modification
is prohibited and will result in damage. Any form of
use other than the stipulated intended purpose can
cause danger to life and cause injury. The product is
for private use only and is not intended for medical
or commercial use. The manufacturer accepts no
responsibility if the intended purpose of this unit is
not adhered to.

Parts description

2 S-connectors
1
2 Silencers
2
2 Covers
3
2 Seals (S-connectors)
4
2 Swivel nuts
5
6 GB/IE/NI
Fitting body
6
Diverter
7
Shower connection
8
LED cover
9
Tub mixer
10
Socket head wrench
11
LED installation wrench
12
Cartridge
13
Cartridge lock nut
14
Cartridge cover ring
15
Handle
16
Locking screw
17
Hot / cold plaque
18

Technical Data

Swivel nut
(water connections):
Shower hose connection: G ½"
Minimum flow pressure:
LED light:
Temperature sensor
tolerance:

Scope of delivery

1 LED tub filling / shower mixer (
2 Caps
3
2 S-connectors with silencer (
2 Seals
4
1 Socket head wrench
1 LED installation spanner
1 Instructions for assembly / operation
G ¾"
1.5 bar
approx. < 33°C blue,
approx. 33–39°C green,
approx. > 39°C red,
approx. > 53°C flashing
red
+/- 2°C
– , –
5 10 13
– )
1 2
11
12
)
18