Preparations For Use; Operation; Switch Over Rinsing Spray; Maintenance And Cleaning - Miomare 273497 Operation And Safety Notes

Assembly / Preparations for use / Operation / Maintenance and Cleaning
Lay the rubber seal
shower hose and screw the union nut onto
5
the thread of the rinsing spray
Lay the rubber seal
the short connection hose
to the shower hose
Fasten the hose weight
at the bottom of the sink in such as way that
5
the rinsing spray
4
tap sufficiently and can still be held securely in
the inserted position.
Fasten the two long connection hoses
pre-mounted seals
appropriate. Ensure that the connection to hot
and cold water is correct.

Preparations for use

After the initial commissioning, check all connections
for leakage carefully.
In order to remove any possible impurities, the tap
has to be flushed before it is used for the first time.
To do this, proceed as follows:
Unscrew the aerator
Open the main water supply and allow the
water to flow for two minutes to flush out any
residues.
The replace the aerator
the rinsing spray again

Operation

Note: If the tap has not been used for a long
period flush the pipes through thoroughly in order
to avoid stagnation and build-up of residues.
Open the main water supply.
Lift the handle and swing it to the right or
1
left in order to regulate the speed or temperature
of the water.
Hot water:
Swing the handle to the left.
1
8 GB
into the union nut of the
3
.
4
into the union nut
24 13
and connect this
12
.
5
to the shower hose
25
can be pulled out of the
to the
10
or to the angle valves, if
11
from the rinsing spray
23
by screwing it onto
23
.
4
Cold water:
Swing the handle
of Check operation of the mixer. To do so, swing
the lever
1
Please check the connections regularly to
ensure that they are tight.

Switch over rinsing spray

The rinsing spray head
over buttons ,
21
Press the top button
activate the shower.
Press the bottom button
aerator .
23

Maintenance and Cleaning

Maintaining and
cleaning the tap
Please note that sanitary taps require special care
. and attention. Therefore, please follow the instructions:
4
When cleaning, never use petrol, solvent, ag-
gressive cleansers or hard cleaning brushes etc.
These could damage the surface of the product.
Dry your taps with a cloth after every use in
order to avoid the build-up of any limescale.
Clean the product with a damp, soft cloth and
a mild cleaning agent if required.
Unscrew and remove the aerator
interval and remove any residues of scale or
foreign bodies. In case of sever contamination
or damage, replace the aerator
one which you can order from the Service
Centre notified to you.
Note: The aerator
screwed by hand. Otherwise use an open-end
spanner SW 22 mm and be sure to wrap the
aerator with a thin damp cloth to prevent
23
damaging it. A pipe wrench with plastic jaws is
also suitable.
Non-observance of the above care advice can be
expected to result in damage to the surfaces of the
to the right.
1
into all permissible positions.
is equipped with change-
4
for the shower function.
22
on the show head to
22
to activate the
21
23
with a new
23
can normally be un-
23
at regular