Installation; Placing - ESAB ESABMig C420 Instruction Manual

GB
Duty cycle
The duty cycle refers to the time as a percentage of a ten–minute period that you can weld at a cer-
tain load without overloading.
Enclosure class
The IP code indicates the enclosure class, i. e. the degree of protection against penetration by solid
objects or water. Equipment marked IP23 is designed for indoor and outdoor use.
Application class
The symbol indicates that the power source is designed for use in areas with increased
electrical hazard.
5

INSTALLATION

The installation must be executed by a professional.
WARNING!
This product is intended for industrial use. In a domestic environment this product may cause radio
interference. It is the user's responsibility to take adequate precautions.
Lifting instructions
The power supply should be lifted by means of its lifting
eye. The handle is only intended for pulling it along the
ground.
5.1

Placing

Position the welding power source so that its cooling air inlets and outlets are not
obstructed.
C420e1
– 7 –