Charging; Charging With The Desktop Holder And Fujitsu Ac Adapter - Fujitsu Arrows Z IS Series Basic Manual

■ Attaching the micro au IC-Card
a
Insert the micro au IC-Card with the IC
contact part facing down into the attaching
part
• Make sure the direction of the cutoff.
• For removing battery pack, see "Removing the battery
pack" ( P.32).
Notch
micro au IC-Card
attaching part
■ Removing micro au IC-Card
a
Press the lock with your finger (①) and pull
micro au IC-Card in the direction ②
• Do not strongly press the micro au IC-Card down.
①
Lock
②
◎ Note the following points, otherwise handling the micro au IC-Card
may cause malfunction or damage.
• Try not to touch the IC (metal) part of the micro au IC-Card or the
IC card terminal inside the ISW13F.
• Insert in the correct direction.
• Do not use force to attach or remove.
◎ When a micro au IC-Card is not attached properly or micro au IC-Card
is abnormal, an error message appears.
◎ Do not lose the micro au IC-Card after it has been removed.

Charging

When you purchase your product, the battery pack is not
fully charged. Make sure to charge the battery pack before
use.
The battery pack is a consumable item. A time available with
each charging decreases bit by bit.
Use supplied USB cable to connect Fujitsu AC adapter.
Charging with the desktop holder and
Fujitsu AC adapter
Charging with the desktop holder and Fujitsu AC adapter is
explained.
• Set "Desktop holder charge setting" to "Quick charge"
beforehand.
a
Insert the USB plug of the supplied USB cable
into the USB connection terminal of the
Fujitsu AC adapter
33