Opening/Closing External Connection Terminal Cover/Stereo Earphone Terminal Cover; Opening External Connection Terminal Cover/Stereo Earphone Terminal Cover; Closing External Connection Terminal Cover/Stereo Earphone Terminal Cover - Fujitsu Arrows Z IS Series Basic Manual

By au
Table of Contents

Advertisement

◎ Do not put a sheet (peep prevention sheet etc.) or decoration seal 
on the proximity sensor/RGB sensor/built-in antenna/GPS antenna/
WiMAX antenna.
◎ Covering the proximity sensor during a call turns off the screen.
◎ Touching or covering the built-in antenna with your fingers or metal 
objects while holding the ISW13F may lower the receiving 
sensitivity.
◎ Covering Temperature/humidity sensor with hand etc. measurement 
may not work properly.
◎ Do not cover the microphone with hand etc. during a call or while 
recording.
Opening/closing external connection 
terminal cover/stereo earphone 
terminal cover
Opening external connection terminal 
cover/stereo earphone terminal cover
a
Put your finger into the groove at the edge of 
the cover to open in the direction of the 
arrow
Groove
30
◎ Be careful not to pull strongly the external connection terminal 
cover/stereo earphone terminal cover. Especially, when removing a 
cable connected to the external connection terminal or stereo 
earphone terminal, if you pull the cable with the cover, excessive 
force might be applied.
◎ Pulling strongly the external connection terminal cover/stereo 
earphone terminal cover may cause the cover to deform, to come off 
from the phone, or to be damaged.
◎ If the external connection terminal cover or stereo earphone terminal 
cover is removed, insert it in the direction as shown pressing the ★ 
part.
Closing external connection terminal 
cover/stereo earphone terminal cover
a
After stowing the cover hinge, press on the 
external connection terminal cover evenly 
with the flat part of your finger
Hinge

Advertisement

Table of Contents
loading

This manual is also suitable for:

Arrows z isw13f

Table of Contents