Table of Contents
Advertisement
The FCC has granted an Equipment Authorization for this model
handset with all reported SAR levels evaluated as in compliance
with the FCC RF emission guidelines. SAR information on this
model handset is on file with the FCC and can be found under the
Display Grant section of
http://www.fcc.gov/oet/ea/fccid/ after searching on FCC ID
YUW-FJI13.
Additional information on Specific Absorption Rates (SAR) can be
found on the Cellular Telecommunications & Internet Association
(CTIA) website at http://www.phonefacts.net.
Declaration of Conformity
The product "ISW13F" is declared to conform with the essential
requirements of European Union Directive 1999/5/EC Radio and
Telecommunications Terminal Equipment Directive 3.1(a), 3.1(b)
and 3.2.
The Declaration of Conformity is found on
http://www.fmworld.net/product/phone/
This mobile phone complies with the EU requirements for
exposure to radio waves.
Your mobile phone is a radio transceiver, designed and
manufactured not to exceed the SAR* limits** for exposure to
radiofrequency (RF) energy, which SAR* value, when tested for
compliance against the standard was 0.165 W/kg for HEAD,
0.246 W/kg for BODY. While there may be differences between
the SAR* levels of various phones and at various positions, they
all meet*** the EU requirements for RF exposure.
*
The exposure standard for mobile phones employs a unit of
measurement known as the Specific Absorption Rate, or SAR.
** The SAR limit for mobile phones used by the public is 2.0
watts/kilogram (W/kg) averaged over ten grams of tissue,
recommended by The Council of the European Union. The limit
incorporates a substantial margin of safety to give additional
protection for the public and to account for any variations in
measurements.
*** Tests for SAR have been conducted using standard operating
positions with the phone transmitting at its highest certified
power level in all tested frequency bands. Although the SAR is
determined at the highest certified power level, the actual
SAR level of the phone while operating can be well below the
maximum value. This is because the phone is designed to
operate at multiple power levels so as to use only the power
required to reach the network. In general, the closer you are to
a base station antenna, the lower the power output.
Export Administration Regulations
This product and its accessories may be subject to the
Japan Export Administration Regulations ("Foreign
Exchange and Foreign Trade Law" and its related laws). In
addition, U.S. Re-export Regulations (Export Administration
Regulations) may apply to this product and its accessories.
To export and re-export this product and its accessories,
take the required measures on your responsibility and at
your expenses. For details on the procedures, contact the
Ministry of Economy, Trade and Industry or the U.S.
Department of Commerce.
Intellectual property rights
■ Trademarks
Company names and product names referred to in this
manual are trademarks or registered trademarks of
respective companies.
• The microSDHC logo is a trademark of SD-3C and
LLC.
®
• The Bluetooth
smart ready word mark and
logo are registered trademarks owned by
®
the Bluetooth
SIG, Inc., and FUJITSU
LIMITED is licensed to use these trademarks.
65
Advertisement
Table of Contents
