Table of Contents
Advertisement
●
Do not use the product in extremely hot, cold or humid places.
(Use within an ambient temperature range of 5℃ to 35℃ and
humidity range of 35% to 85%.)
− Charging equipment
− Cables
●
Do not use the product in extremely hot, cold or humid places.
(Use within an ambient temperature range of 5℃ to 35℃ and
humidity range of 35% to 90%. Temporary use at 36℃ to 40℃ is
allowed.)
− ISW13F main unit
− Battery pack, micro au IC-Card (attached to the ISW13F main
unit)
●
Do not use in places subject to lots of dust or vibration.
●
Clean the charging terminals with dry cotton swabs, etc. every now
and then. Soiled terminals might cause poor connection. Do not
exert a strong force to clean the charging terminals to prevent
deformation.
●
When the product is dirt, wipe with a soft wry cloth. Wiping the
product using benzene, thinner, alcohol, detergent, etc. might erase
the printing on the outer casing or cause discoloration.
●
Use as far away as possible from household appliances (TVs,
speakers, etc.). Use nearby might affect them.
●
The ISW13F may become warm while calling, watching TV (1Seg),
or charging, depending on the situation, but this is not abnormal.
●
Do not subject to strong impact to the fingerprint sensor, or
scratch its surface. It may cause not only malfunction of the
fingerprint sensor but also disabling authentication.
●
Wipe the fingerprint sensor with a soft dry cloth. When the
fingerprint sensor is dirty or gets wet on the surface, it cannot read
the fingerprint and may cause decrease the authentication
performance or erroneous operation.
●
When removing the battery pack, make sure to turn off the ISW13F.
If you remove the battery pack with the power on, saved data might
be altered or lost.
14
●
Attach the battery pack to the ISW13F main unit in the correct
orientation. Failure to do so might cause damage or a fault. If the
battery pack cannot be attached correctly, do not force the battery
pack onto the product. Check "Attaching the battery pack" before
retrying to attach.
●
Attach the specified charger to the ISW13F main unit, check the
connector form of the charger and connect in the correct
orientation. Failure to do so might cause damage or a fault. If the
charger cannot be connected correctly, do not force the charger to
the product. Check "Charging with Fujitsu AC adapter" before
retrying to connect.
●
When the product is used by a child, guardians should teach the
child how to use it to avoid a risk. Also, take care that the child uses
the product according to the instructions. Failure to do so might
cause injuries.
■ ISW13F main unit
●
Do not remove the stickers printed with the serial numbers that can
be seen on the ISW13F main unit (when the battery cover is
removed). These stickers prove that the ISW13F you are using
comply with the Wireless Telegraphy Act and Telecommunications
Operations Act.
●
Never use modified au cell phones. Use of a modified device
violates the Radio Law. This product has acquired the certification
of conformity with technical regulations for the specified radio
station based on the Radio Law, and the "Technical Conformity
Mark
" is printed on the nameplate of the product as a certificate.
If the screws of the au cell phone are removed and modifications
are made to the internal components, the certification of conformity
with technical regulations will become invalid. Never use the
product without the valid certification. Doing so violates the Radio
Law.
●
Contents saved in the ISW13F, such as contacts, mails and
favorites, might be altered or lost by an accident, fault, repair or
mishandling. Be sure to keep a copy of important contents. Note
that Company assumes no responsibility for any damages or lost
profits resulting from altered or lost contents.
Advertisement
Table of Contents
