Validation
Targets
Auto
Recalibrate if
ΔE2000 > 2
Flash Color
Patches During
Warm-up
Calibration
Module Power
Show Last
Validation
Results
Reset
Validation
│
60
Operating the Monitor
Allows you to set the validation target to S1: DCI P3
D65 G2.4 L100, S2: BT.709 D65 BT.1886 L100,
S3: BT.2020 D65 BT.1886 L100, S4: sRGB D65
sRGB L120, S5: Adobe RGB D65 G2.2 L160,
S6: Adobe RGB D50 G2.2 L160, H1: HDR10 D65
ST.2084(PQ) L1000, H2: HDR D65 HLG L1000, CAL
1*, or CAL 2*.
*For targets supported by built-in calibration.
Allows you to set the Auto Recalibrate if ΔE2000 > 2
to Yes or No.
NOTE: Function name on your display may vary.
Allows you to set the Flash Color Patches During
Warm-up to Yes or No.
Allows you to set the Calibration Module Power to
On or Off .
NOTE: Calibration Module Power must be On to
enable Validation function.
Allows you to examine the most recent validation
results.
Select this option to restore default Validation
settings.