Dell UltraSharp UP3221Q User Manual page 58

Calibration
Targets
Flash Color
Patches During
Warm-up
Calibration
Speed
Calibration
Warm Up Time
Built-in
Colorimeter
Profile
│
58 Operating the Monitor
Allows you to set the calibration target to S1: DCI P3
D65 G2.4 L100, S2: BT.709 D65 BT.1886 L100, 
S3: BT.2020 D65 BT.1886 L100, S4: sRGB D65
sRGB L120, S5: Adobe RGB D65 G2.2 L160, 
S6: Adobe RGB D50 G2.2 L160, H1: HDR10 D65
ST.2084(PQ) L1000, H2: HDR D65 HLG L1000, User
1, User 2, User 3, CAL 1, or CAL 2.
NOTE: The following Color Space options are not
available as calibration targets: Native, User 1, User 2,
and User 3.
Allows you to set the Flash Color Patches During
Warm-up to Yes or No.
Allows you to set the calibration speed to Express or
Comprehensive.
NOTE: When Express is selected, the calibration time
is approximately 4 minutes. When Comprehensive is
selected, the calibration time is approximately 10
minutes.
Set the warm up time to 20 mins or 30 mins.
Allows you to set the Built-in Colorimeter Profile to
Default or Correlated (correlated with external
colorimeter).
Switching the profile may cause inconsistent result to
previous calibration. It is recommended to re-calibrate
the monitor after switching profile.
NOTE: User can apply different calibrator profiles. To
select Correlated profile, user must correlate the
monitor with an external colorimeter via Calman Ready/
Calman Powered first. When correlation is under
processing, Calman Ready/Calman Powered will drive
the monitor's internal calibrator to the position and start
the process with the external colorimeter. After
completing the complement of the correlation, Calman
Ready/Calman Powered will set the correlation
parameters to the monitor to enable this item.