Table of Contents
Advertisement
Color Space
When you select Color Space, you can choose one of
the following: S1: DCI P3 D65 G2.4 L100, S2: BT.709
D65 BT.1886 L100, S3: BT.2020 D65 BT.1886 L100,
S4: sRGB D65 sRGB L120, S5: Adobe RGB D65
G2.2 L160, S6: Adobe RGB D50 G2.2 L160, Native,
H1: HDR10 D65 ST.2084(PQ) L1000, H2: HDR D65
HLG L1000, User 1, User 2, User 3, CAL 1, or CAL 2.
NOTE: The factory preset mode S1: DCI P3 D65 G2.4
L100 differs from DCI-P3 spec (P3 White point, 48 cd/
m2).
NOTE: User may use either User 1, User 2, or User 3
to set preferred color space parameter. E.g.: Color
Space > User 1 > Color Gamut (DCI-P3) > White
Point (D50) > Gamma (2.6) > Luminance
(48 cd/m2).
Manual HDR mode without color volume metadata
presented in video content may be achieved via User 1,
User 2, or User 3, allowing force selection of HDR
EOTF between ST.2084(PQ) and HLG.
NOTE: Calibrate User 1, User 2, or User 3 settings
directly to CAL 1 or CAL 2.
NOTE: Factory Reset will not remove calibrated data.
User may go to Color > Color Space > Reset Color
Space S# (1~6) to manually remove selected
calibration data. Calibration data of CAL 1 and CAL 2
cannot be removed from the OSD.
NOTE: HDR color space options are available only
when HDR input source is detected.
│
48
Operating the Monitor
Advertisement
Table of Contents
