Checking The V-Belt, Tightening, Replacing If Necessary - Fayat Group BOMAG BVP 10/36 Operating Instructions Manual

Maintenance every 6 months
5.16 Checking the V-belt, tight-
ening, replacing if neces-
sary
Checking the V-belt
Fig. 44
Remove the V-belt guard.
l
Check the condition and tension of the V-belt,
l
replace the V-belt if damaged.
Compression measurement approx. 5 mm
l
(Fig. 44).
Changing the V-belt
Fig. 45
Slightly loosen two fastening screws (1) (Fig.
l
45) on both sides of the engine carrier.
Push the motor carrier forward and take the V-
l
belt off.
Install the new V-belt.
l
46
*Always follow manufacturer instructions*
BOMAG
*AAA Rent-All 225-291-1356*
Tightening the V-belt
Fig. 46
Pull the engine carrier back (Fig. 46) until the
l
correct V-belt tension is achieved and tighten
the four fastening screws.
Assemble the V-belt guard.
l
Caution
!
Check the V-belt tension again after a running
time of approx. 25 operating hours, retighten if
necessary.
BVP 10/36, BVP 18/45