Clean The Cooling Fins And The Cooling Air Intake Openings - Fayat Group BOMAG BVP 10/36 Operating Instructions Manual

Maintenance every m onth
5.11 Clean the cooling fins and
the cooling air intake open-
ings
Caution
!
Dirty operating conditions, particularly lubri-
cation oil and fuel deposits on the cooling fins
of the engine and the cooling air intake open-
ing have an adverse effect on the cooling of
the engine.
You should therefore immediately seal any oil
or fuel leaks near fuel tank, cylinder or cooling
air intake.
Fig. 37
Loosen dried on dirt with a suitable brush (Fig.
l
37) from all cooling fins and cooling air intake
openings and blow it off with compressed air.
Danger
!
Fire hazard!
Do not use any inflammable solvents.
Caution
!
Do not guide the water jet directly into the
cooling air openings of the recoil starter, into
the dry air filter and on electrical equipment.
On a oil contaminated engine use a cold
l
cleansing agent for cleaning.
BVP 10/36, BVP 18/45
*Always follow manufacturer instructions*
BOMAG
*AAA Rent-All 225-291-1356*
Maintenance every month
After a sufficient soaking time clean off with a
l
water or steam jet and blow out with com-
pressed air.
Run the engine warm for a while to avoid cor-
l
rosion.
Caution
!
Look for the cause of oily contamination and
have any leaks sealed by the customer service
of BOMAG.
41