Installing The Battery Backup Module; Installing The Controller - Adaptec SCSI RAID 2100S Installation Manual

Adaptec RAID Installation Guide

Installing the Battery Backup Module

To install the battery backup module in Adaptec 3200S, 3210S,
3400S, and 3410S controllers, plug it in as shown below.
Note: The socket location in the figure below is for
Adaptec 3200S/3400S controllers only. Refer to
for socket locations on Adaptec 3210S/3410S controllers.

Installing the Controller

To install the controller in the system cabinet
1
Connect the computer's disk activity LED cable to the
appropriate connector on the controller. See
the location of this connector for your controller model.
Ensure that the positive lead of the LED cable (usually a red
wire or a wire marked with a red stripe) is attached to pin 1
or 3 and the negative lead (usually a black wire) is attached to
pin 2 or 4.
2
Connect any internal drive cables now.
3
Install the controller in an available 32- or 64-bit PCI bus slot
and secure the controller bracket to the host system cabinet
with the screw provided with the system.
In a system with multiple controllers, the controller that has
the lowest BIOS ROM address (typically, the lowest numbered
PCI slot) will become the booting controller. If you require the
RAID controller to become the booting controller, you may
2-8
Appendix A
Appendix A for