Installing The Driver In A Existing Netware - Adaptec SCSI RAID 2100S Installation Manual

Adaptec RAID Installation Guide
8
Insert the driver disk you created in
This utility copies the necessary files to the
9
Run
install.bat
10
When asked to select a disk driver select i2opci.nlm. Enter the
slot number where the controller is installed and press F10.
11
Select Save parameters and load driver.
12
Select Yes to select another driver.
13
Select bkstrosm.ham. Enter the slot number where the
controller is installed and press F10.
14
Select Save parameters and load driver.
15
Install any additional drivers and continue the installation.
16
Select Edit startup.ncf. If needed, edit the file so that
is listed before
17
Continue with the NetWare installation according to the
Novell documentation.
18
Upgrade your NetWare version to the minimum patch level
specified by Novell.
Installing the Driver in a Existing NetWare 4.11 Server
In this scenario, you are integrating an Adaptec RAID controller into
an existing NetWare 4.11 server as a secondary controller. To install
the driver
1
Upgrade your existing NetWare server to the minimum patch
level specified by Novell.
2
Create a driver floppy disk using the Adaptec RAID Installation CD.
To create the disk
a
Insert the Adaptec RAID Installation CD in your drive and a
blank floppy disk in the floppy disk drive.
b
Copy all the files in
floppy disk.
c
Remove the Adaptec RAID Installation CD and the driver
floppy disk.
3-20
from the drive.
C
in your
bkstrosm.ham
\packages\netware\4.11\driver
Step 1 and run
drive.
C
file.
startup.ncf
to the
.
dpt411.bat
i2opci.nlm