Hrconf Romupdate; Hrconf Setboot; Hrconf Setconfig - Adaptec RAID 2045 User Manual

hrconf romupdate

Note:
This command is only available on systems running Windows or Linux.
Updates the controller or enclosure firmware. The ROM image file must be in the same
directory prior to invoking hrconf.
Syntax
HRCONF ROMUPDATE <Controller#>[CONTROLLER] <Filename>
Parameters
Controller# is the controller number
Filename is the relative or absolute path with filename
Channel# is the channel number for the device
Device# is the device number for the drive.
Example
HRCONF ROMUPDATE 1 CONTROLLER AS4830.UFI

hrconf setboot

Marks a logical device bootable.
Syntax
HRCONF SETBOOT 1 LOGICALDRIVE 1
Parameters
Controller# is the controller number
LogicalDrive# is the number of the logical drive to mark bootable.
Example
HRCONF SETBOOT 1 LOGICALDRIVE 1

hrconf setconfig

Resets the controller's configuration.
Syntax
HRCONF SETCONFIG <Controller#> DEFAULT [noprompt]
Parameters
Controller# is the controller number
Default resets the controller's configuration. Logical drives are deleted, disk drives are reset to
the ready state, and any controller settings are reset to default values.
Noprompt: (optional) Do not prompt for confirmation.
Example
HRCONF SETCONFIG 1 DEFAULT NOPROMPT
Chapter 2: Using the Command Line Utility
27
●