Arcconf Rescan; Arcconf Resetstatisticscounters; Arcconf Romupdate - Adaptec Command Line Utility User Manual

arcconf rescan

Enables the controller to check for the removal of any disk drives in the ready state and to check
for the connection of any new disk drives to the controller. The command returns when the
rescan is complete.
Syntax
ARCCONF RESCAN <Controller#>
Parameters
Controller# is the controller number
Example
ARCCONF RESCAN 1

arcconf resetstatisticscounters

Resets statistics counters for a controller. Use this command to clear the counters and create
fresh statistics.
Syntax
ARCCONF RESETSTATISTICSCOUNTERS <Controller#>
Parameters
Controller# is the controller number.
Example
ARCCONF RESETSTATISTICSCOUNTERS 1

arcconf romupdate

Allows new firmware and BIOS to be flashed to the controller. A reboot is required for the new
firmware to take effect.
Note:
This function is only supported in Windows and Linux.
1
Be sure to copy the *.UFI update files from the DVD and not from the BIOS/Firmware
2
update diskettes.
Syntax
ARCCONF ROMUPDATE <Controller#> <BaseName> [Newversion <build#> [Force]]
[noprompt]
Parameters
Controller# is the controller number
BaseName is the name of the ROM image basename or the fully qualified name if you have a
set of controller ROM images.
Note:
All UFI files must be in the same directory prior to invoking ARCCONF. If you are copying
UFI files from floppy images, be sure to check all images.
Newversion <build#> specifies the version of the firmware build.
Chapter 2: Using the Command Line Utility
28
●