Setting; Direct Power On; Standby Mode; High Land Function - Eiki EK-850LU Owner's Manual

Setting

Your projector comes with convenient adjustment function.
1 Press the MENU button on remote controller and the OSD displays. Press
Setting icon, press
2 Press button to point to required item and press OK button to confirm your selection.

Direct power on

Setting the projector to be turned on automatically
just by connecting the AC power cord.
On ... Start the projection immediately.
Off ....Start up in the standby mode.

Standby mode

Setting the power consumption in standby mode.
Eco......... Restrict some functions in thestandby
mode to reduce power consumption. In this
case, you could control the projector wiht
limited.
Normal ... Do not restrict network function and
serial communication function even in the
standby mode.
LAN RS232C Keypad IR Control HDBaseT
ECO х Δ
Normal √ √
х: No Control Δ: Power On command Only
√: All commands are active
High land
Control the fan speed while cooling according the operating condition.
Off ... Normal speed. Set it so if the projector is operated at a lower altitude.
On ... Faster than Off. Set it so if the projector is operated at a higher altitude.
Note:
● When operating the projector at an altitude around 1400~2700m, please setting as ON.
Cooling fast
provides the following options in the cooling fans' operation after turning off the projector.
Normal .. As default cooling time.
30 sec ... Faster cooling time and louder noise of fan.
0 sec ..... Allow you to unplug the AC power cord immidiately without cooling.
52
OSD setting-Setting
button or OK button to confirm your selection.
Δ Δ
Δ Δ
Setting
Direct power on
Standby mode
High land
Cooling fast
Key lock
Contrast optimization
Laser control
Remote Control
HDMI Setup
х
Δ
button to select
Off
Eco
Off
0 sec
Off