Inepro PM - Copy Coin CM7000 - Xerox Config Technical Manual page 33

Appendix I
Function 65 not applicable
Function 66, Output 2 mode
Standard it is in the OFF position.
Function of the parameters:
Value Description
Off Normal, Default position
Inp 2 Input 2
Inp 3 Input 3
Inp 4 Input 4
Inp 5 Input 5
Function 67 to f unction 70 not applicable
Function 71 to 78, Coin value
The coin v alue is programmed in this f unction. The connected coin reader only determines
whether or not the inserted coin is a v alid coin. The coin reader emits a pulse to the Pay Matic
® electronics at accepting a coin. The Pay Matic ® attributes a v alue to the incoming pulse.
The coin v alue, which will be introduced, has to be div ided by the basic v alue (f unction 79). If
the f unction 79 is at 1 (Euro standard), the introduced v alue also is the coin v alue.
Function 71 corresponds with coin 1, f unction 72 with coin 2 etc.
Function 79, Basic value
The copy prices and the coin v alues will be calculated based on the basic v alue. If the v alue
is at 1, the calculation f or these copy prices and coin v alues is not necessary . If the basic
v alue is at e.g. 5, all programmed copy prices and coin v alues are multiplied with this basic
v alue.
Function 80 not applicable
Function 81 to f unction 85, Display presentation settings
All these f unctions inf luence the presentation on the display . All these f unctions are described
below;
Function
Switch on both outputs when there is enough credit for one copy.
Switch on output 2 when there is enough credit for an A3 copy.
Switch on output 2 when there is enough credit for a colour copy.
Switch on output 2 when there is enough credit for a duplex copy.
Only functional when "Level" is chosen in function 87.
27