Connection To The Copier; Installing Mounting Bracket - Inepro PM - Copy Coin CM7000 - Xerox Config Technical Manual

Connection to the copier

The Pay Matic ® COIN Copy is connected to the key counter interf ace of the copier. Some
copiers need more signals f rom other places then the key counter. Please check upf ront
where the connection f or the coin box is located. Some copiers are supplied with a plug and
play connector. Inepro keeps a large copier database where all interf aced copiers are stored. If
y ou need specif ic inf ormation please check the documentation or contact Inepro.
Bef ore connecting the Pay Matic ® COIN Copy check the f unctionality of the copier without
the coin box to make sure that the copier is f unctioning properly .
·
Switch of the copier
·
Connect the interf ace cable f rom the coin box to the copier
·
Switch on the copier and the coin box
·
Setup the proper menu settings on the copier, if required. Please note that each ty pe of
copier can hav e it's own specif ic interf ace cable and copier settings.
·
Setup the coin box, see setup chapter
·
Test the copier and the coin box.

Installing mounting bracket

Follow the instructions of the diagram which is packed with the mounting kit.
PayMatic ® column (optional)
The Pay Matic ® column is av ailable as an optional extra. The Pay Matic ® column is made of
steel, is 66 cm high and can easily be placed below any ty pe of Pay Matic ®. With the
Pay Matic ® column there is no need f or a coin box, as there is one integrated in the Pay Matic
® column. Thanks to its asy nchronic bottom panel, the Pay Matic ® column is multi f unctional.
The wheels of the copier are jammed into the cav ities of the bottom panel to f ix the Pay Matic
® column and immobilize the copier.
8 - PM - Copy Coin CM7000 - Xerox Config
Connection to the copier