Inepro IP Reader Technical Manual page 40

Name
Key Descr iption
The name of this IP reader (like 'P rinter Q 745') This name w ill also be used as
N ame
host name, it is sent to the DH C P serv er and DN S serv er if they are enabled.
IP config
Key Descr iption
Dy namic H ost
E nabled if DH C P be used, disabled if the netw ork information need to be filled
C onfiguration
out manually .
P rotocol
IP The IP -address for the IP reader.
The netmask (only used w hen using subnetting, ask y our sy stem
N etmask
administrator, if y ou're not sure). S tandard v alue 255.255.255.0
The IP address of the gatew ay (The gatew ay is de serv er that is located
G atew ay betw een tw o netw orks, like the Internet and y our local netw ork). It is usually
the same address as the DN S serv er.
Domain N ame The IP address of the serv er w ith the Domain N ame S y stem, the sy stem that
S y stem transforms names to IP -addresses and v ice v ersa.
Server config settings
Key Descr iption
S erv er 1 IP The address of the serv er that the IP reader should contact.
The address of the back-up serv er that the IP reader should contact. It w ill be
S erv er 2 IP
contacted if the first serv er does not respond.
When DN S is used the name of the serv er can be entered, the IP -address
S erv er 1 name
v alue for this serv er w ill be ignored, and retriev ed from the DN S serv er.
When DN S is used the name of the serv er can be entered, the IP -address
S erv er 2 name
v alue for this serv er w ill be ignored, and retriev ed from the DN S serv er
Key set w ill giv e the possibility to set the encry ption key betw een the IP
Key set reader and the serv er. A t the time of w riting the v alue as not y et used and
should alw ay s be set to '1'.
Reader config settings
Key Descr iption
S etting 1
S etting 2
S etting 3 These settings w ill be addressed below .
Data 1
Data 2
These fields will be used for retrieving the card reader data. The
values entered here are dependent on the card that is used.
Note: The raw data is supplied without conversion. Below you
will find the data that applies to the data supplied in a decimal
format.
32 - IP Reader