Running The Afu From The Gui - Adaptec 2025ZCR Installation And User Manual

2 Create additional bootable MS–DOS floppy disks and copy each
additional
AAxxx0x.ufi
have two UFI files; some have four.)
3 Start the AFU as described in
page C-4 and follow the prompts.

Running the AFU from the GUI

The easy way to run the AFU is to use its Graphical User Interface
(GUI). If you prefer to run the AFU from the command line, see
page C-5.
To access the AFU:
1 Create the firmware floppy disks, as described in
Firmware Floppy Disks on page
2 Shut down your operating system and reboot to DOS from a
bootable MS-DOS floppy disk or from a DOS partition on a
bootable drive. (You can use the drive connected to the
controller you are updating.)
Note: When updating the controller flash, I/O is not
possible. Before you can use the controller again, complete
the flash operation and restart the computer.
3 At the DOS command prompt (typically
arguments.
The AFU's main menu is displayed.
4 Choose Select Controllers and select the Adaptec RAID
controllers to be flashed.
5 Choose Select an Operation.
6 Choose any available AFU function and follow the on-screen
instructions.
files to a separate disk. (Some controllers
Running the AFU from the GUI on
C-3.
Adaptec Flash Utility (AFU)
Creating the
), type AFU with no
A:\>
C-4